Interior lights that stay on after every door is closed almost always trace back to a door jamb switch the body control module thinks is still open, though wiring damage and a stuck dome light switch are also common culprits.
Jump to a section: Check for a timeout first · Door jamb switch issues · Dome light switch · Wiring problems · Quick reference table · FAQ
Check for a Timeout First
Give the vehicle 10-20 seconds after closing all doors, since most Equinox models have a built-in delay timer before the interior lights shut off on their own.
Door Jamb Switch Issues
If the lights stay on with all doors confirmed closed and the manual light switch set to off, the vehicle likely thinks a door remains open due to a faulty or misaligned door jamb switch, most commonly on the passenger side. Test each door by opening and closing it a few times to see if it affects the light, and inspect the switch for debris, corrosion, or physical damage; cleaning or lightly lubricating it often resolves an intermittent switch.
Dome Light Switch
If door switches all test fine, inspect the dome light's own control switch, since a stuck or damaged switch there can cause constant power flow to the light regardless of door status.
Wiring Problems
In some documented cases, a melted ground wire in the interior lighting harness kept power flowing to the map lights at all times; if switches test fine, a wiring inspection with a multimeter for continuity issues is the next step.
Quick Reference Table
| Cause | How to Check |
|---|---|
| Timeout delay | Wait 10-20 seconds after closing doors |
| Door jamb switch | Open/close each door, inspect for debris or damage |
| Dome light switch | Inspect switch for sticking or damage |
| Wiring harness | Check continuity with a multimeter |
Frequently Asked Questions
Will this drain my battery if I don't fix it?
Yes — lights left on continuously, especially overnight, can drain the 12-volt battery, so it's worth addressing promptly rather than letting it run indefinitely.
Can I just disconnect the light as a workaround?
You can temporarily pull the bulb or fuse to stop the drain, but that only masks the underlying door switch or wiring issue rather than fixing it.
Which door is usually the culprit?
The passenger door jamb switch is the most frequently cited culprit in owner reports, though any door switch can be responsible.
Is this covered under warranty?
A faulty door switch or wiring defect is often covered if your Equinox is still within its factory warranty period, so check with your dealership before doing DIY repairs on a newer vehicle.
Shop the Parts Mentioned
-
MOTOPOWER MP69033 OBD2 Scanner — $49, reads and clears engine-side (P) codes. Door-status and interior lighting faults are body codes and need a scanner that covers body systems.
-
VDIAGTOOL BT500 Battery Tester — $57.53, tests battery health, cranking and charging on 6V/12V/24V systems with ripple analysis and a voltage waveform — rules out low system voltage, a common trigger for spurious module codes.
-
ACDelco Gold Negative Battery Cable — for replacing a corroded or damaged negative cable, a common source of intermittent electrical faults.
-
95-Piece Mechanics Tool Set (Metric & SAE) — covers the fasteners for door panel and switch access.
-
Portable Car Jump Starter with Air Compressor — backup in case the drain leaves your battery too low to start.